Below is a testimonial from James, a metal worker in Oregon who has experienced first hand the cut resistant properties of the Majestic #3435 Dyneema glove. James clearly believes the glove saved his hand from serious injury and possible emergency treatment.
James writes...
“Using the Majestic cut-resistant gloves, I was breaking 14ga parts out of a 4' x 8' steel skeleton. This skeleton frame was extremely awkward to handle and the inside corners were unusually sharp. I was folding the skeleton in half to throw it away and part of it fell down onto the top of my left hand. Naturally my instinct was to pull my hand out but I wasn't fast enough. The sharp corner poked into my hand slightly and as I was pulling my hand out of the way it dragged across the top of my hand about four inches. I know from past experience, the weight of the skeleton and the sharpness of the corner that if I were wearing no gloves, or any other type of glove it would have cut deeply into my hand I would have had to have been rushed to the hospital. Instead there wasn't a mark on my hand and all I had to do was get a new glove and go back to work. I wish I had these gloves ten years ago when I started working with sheet metal".
|