Pur Fill 1G is our most versatile foam! It's a moisture-curing foam that expands in place to bond and seal holes and gaps, stopping the passage of air, gases, water, dust, fibers, sound, rodents, pests, radon and odors. Our professional gun dispensers have the added features of complete control, no messy clean-ups or wasted foam.
- Labor Savings
- Low Cost
- Complete Control
- Unlimited Start-ups and Closures
- No Cleaning
- 45 minute cure time
- Professional Pageris Foam Gun
- High Volume
- U.S.D.A. Approved
- 12 Dispensed Gallons
- ½" Bead = 1200 lin.ft
- 2820 Cubic Inches
- 1.6 Cubic feet
- 19 Board feet
IMPORTANT: PLEASE READ FOR BEST RESULTS
ONCE A CAN IS ON THE GUN, ALWAYS LEAVE A CAN ON THE GUN
This will assure no moisture from entering the system to clog up the gun.
SHAKE THE CAN WELL
This will mix the propellant and resin for a better cell structure.
CAN TEMPERATURE SHOULD BE OVER 60 F
This will assure optimum performance and highest volume. In cold temp, warm the can before foaming.
MIST THE SURFACE WITH WATER BEFORE FOAMING
Pur Fill is a moisture curing foam. This water will assure complete cross section curing.
TIGHTEN SET SCREW WHEN FOAMING IS ENDED
This will assure no accidental misfiring if the trigger bumps into anything.
USE SOLVENT CLEANER ONLY WHEN NECESSARY
Solvent cleaner will break down to resin and coat the inside of the gun. Best maintenance is ALWAYS
LEAVE A CAN ON THE GUN.
THESE TIPS SHOULD EXTEND THE LIFE OF THE GUN.
PLEASE TRAIN EVERYONE THAT USES THE SYSTEM BECAUSE IF THEY LEAVE THE
CAN OFF THE GUN FOR MORE THAN 15 MINUTES THERE WILL BE DAMAGE TO THE